Eekay Heat Resistant Aluminum Based Paint 200⁰C - 400⁰C
Heat resistant paint 400 degree is a specialized coating designed to protect surfaces from high temperatures and thermal degradation. It's formulated to withstand heat, prevent rust and corrosion, and maintain its protective properties even under extreme heat conditions. Unlike regular paints, heat resistant paints can handle temperatures ranging from moderate to very high, depending on the specific product.
Product Features
- Resistant for dry heat up to 200⁰C - 400⁰C.
- Good water resistance.
- Good weather resistance.
- Can be applied on MS surface.
| Color | Aluminum / Black |
| Finish | Glossy |
| Volume Solids | 25 |
| Recommended DFT | 90 to 100 Sq Ft / liter / coat |
| Drying Time |
|
| Viscosity | 40 – 45 Sec |
| Over coating |
|
| Flash Point | Not less than 24⁰C |
| Recommended Thinner | Eekay H. R. Thinner |
Direction to use
Surface Preparation
General
- Surface preparation and substrate condition should be dry and free from all contaminations, dust, grease, oil, etc. surface to be sufficiently roughened prior to painting.
- Surface should be checked and treated in accordance with solvent cleaning.
Blast Cleaning
- Steel, blast clean to Sa 2.5 of Swedish Specification
- A blasting profile of (Rz) 35 – 50 microns is recommended.
Application Conditions
- Substrate temperature should be atleast 3⁰C above dew point but not above 45⁰C
- Relative Humidity should be ≥85%
- Good ventilation is required in confined areas to ensure proper curing.
Mixing
- If settling is observed in the drum, loosen the material with the help of hand stirrer, followed by power driven stirrer if needed.
- Add medium and paste and properly stir to get a homogenous mixture.
| Application | Recommended Thinner | Volume of Thinner | Nozzle orifice | Nozzle Pressure |
| Brush / Roller | Eekay HR Thinner | Not required | NA | NA |
| Air Spray | Eekay HR Thinner | 5 - 15% | 1.5 – 3.00 mm | 0.3 – 0.4 MPa |
| Airless Spray | Eekay HR Thinner | 0 - 10% | 0.28 – 0.33mm | 10 – 13 MPa |
Cleaning
- Do not allow the product to remain in hoses, gun or spray equipment.
- Clean all equipment’s immediately after use with Eekay HR Thinner.
- It is recommended to flush out spray equipment during the course of working.
Product Characteristics
- The maximum performance is achived after complete drying.
- At higher relative humidity, drying may get affected.
- The product must not be applied on hot surfaces.
Storage and Packing
- Store in cool and dry place.
- Store in accordance to local regulations.
- Packing will be made available in 4 and 20 liters pack size.
Safety Information
- As a general safety measure, inhalation of solvent vapors, contact with eyes should be avoided.
- While application area should be well ventilated.